The display flashes with the message "Flow"
If the message "Flow" flashes on the KORROSTOP4.0® display, please check the settings for "Config Alarm" to determine whether the KORROSTOP4.0® is set to…
What do the different cover colours mean for the E.KO IONISER®?
The lid colours refer to the application of the E.KO IONISER®. The E.KO IONISER® with the lid colours yellow and grey are used in the…
Why do I have to flush the E.KO IONISER® before use?
The E.KO IONISER® is supplied with a preservative. Before use, this preservative should be flushed out by the flushing process.
The E.KO…
How do I flush the E.KO IONISER?
For the flushing process, you need an LT or CPC coupling ½" and an LT or CPC plug ½". Both LT connectors can be found in your CONNECT4 connection kit. Connect the…
What is the max. operating pressure of the E.KO IONISER®?
The max. operating pressure of the E.KO IONISER® is 5 bar. The unit will be destroyed in case of overpressure!
The max. operating pressure…
When does the E.KO IONISER® reach its full capacity?
To keep the start-up phase as short as possible, the E.KO IONISER® is filled with deionised water. Once the E.KO IONISER® has been connected to…
How do I connect the E.KO IONISER correctly?
Depending on whether you are using an E.KO IONISER® 1501 or 1502/1503, the CPC quick couplings (coupling and plug) for inlet and outlet are positioned…
What do I need to connect the E.KO IONISER?
With the CONNECT4 connection kit, you can connect the E.KO IONISER® to any EDM machine (manufacturer independent). Thanks to the step nozzle and the two…
What is the capacity of the E.KO IONISER®?
The system corresponds to a capacity of 200 litres of mixed bed resin. This performance was measured with new (non-regenerated) mixed bed resin, in a 20…
